Technical guide, , by Green Automatica engineering team · 2 min read
Omron PLC, HMI and inverter programming in Kenya: CP1E, CP2E, NX1P and Sysmac Studio
Programming Omron CP and CJ PLCs with CX-Programmer, NJ and NX controllers with Sysmac Studio, NB and NA HMIs, and MX2 inverters.
Omron controllers, sensors and HMIs are common on packaging, food and assembly machines. We program and troubleshoot Omron PLCs, HMIs and inverters, from compact CP1E controllers to Sysmac NX machine controllers with EtherCAT motion.
Omron equipment we program and configure
| Equipment | Product families | Software we use |
|---|---|---|
| PLCs | CP1E, CP1H, CP2E, CJ2; NX1P2, NJ and NX controllers | CX-Programmer (CX-One), Sysmac Studio |
| HMI | NB series, NA series, NS series | NB-Designer, Sysmac Studio, CX-Designer |
| VFDs | MX2, RX2, M1 series | CX-Drive, Sysmac Studio, keypad |
Networks and protocols: EtherNet/IP, EtherCAT, Host Link and Modbus RTU.
What we do on Omron systems
- Program changes on packaging and food machines: sequences, timers and counters
- Replacing older CPM and CP1 controllers with current models
- NB and NA HMI screen updates and alarm handling
- MX2 inverter setup for conveyors, mixers and fans
How we work on your Omron system
- Back up first. Before we touch anything, we upload and save the existing program, HMI project and drive parameters, so the machine can always be returned to how it was.
- Understand the process. We walk the machine with your operators and maintenance team, and agree in writing what the change or new program must do.
- Program and test offline. Logic, screens and drive settings are prepared and checked before site work, to keep downtime short.
- Commission on site. We test every input, output, interlock and alarm with your team, then run the machine under real load.
- Hand over properly. You receive the final, commented program, HMI project, drive parameter files, I/O list and drawings, plus training for your technicians.
Practical tips from our engineers
Use the right Omron software
CP and CJ PLCs use CX-Programmer in the CX-One suite, while NJ and NX controllers and NA HMIs use Sysmac Studio. Keeping both installed and licensed avoids delays on site.
Document I/O before changes
Omron machines are often heavily modified over the years. A current I/O list and commented program make every later change faster and safer.
Detailed Omron guides
- Omron PLC programming in Kenya
- Omron HMI programming in Kenya
- Omron VFD programming and commissioning in Kenya
Related services
See our PLC programming, SCADA and HMI and VFD and drives services, or read our overview of PLC, HMI and VFD programming for every major brand.
Frequently asked questions
Do you program Omron PLCs?
Yes. We program CP1E, CP1H, CP2E and CJ2 PLCs with CX-Programmer, and NX and NJ controllers with Sysmac Studio.
Can you set up Omron MX2 inverters?
Yes, with CX-Drive or the keypad, including speed control from the PLC.